Gas spring

Q: Is it possible to repair the gas spring?

" This part cannot be repaired. The eventual problems can be resolved by replacing. Dismantling of the part is dangerous, because it is filled with high pressure gas. The following faults indicate that replacement is necessary: Oil stains on the cover Corrosion traces Fails to operate It is desirable to replace them in pairs, because their life span is identical. It is recommended to apply lubricant regularly on the fastening elements for extending the life span. "

Q: Is it complicated to replace the door telescope?

" The steps of replacement might vary depending on the model and make, but the replacement is to be made with the following steps generally: Fix the luggage compartment cover in open condition with some supports. Remove the cover of luggage compartment as necessary for getting access to the fastening elements. Remove the gas spring. It is required to vent the new part: Push the rod into the cylinder until it stops Wait a few seconds and release it, so that it would return to its original position. Repeat this procedure 10 times Install the new part Check the proper operation of the new part "

SELECT YOUR VEHICLE TO FIND THE RIGHT PARTS!

Car
Motorcycle
Commercial vehicle
VIN number

Normal search
Extended search

It is mandatory to fill out the vehicle identification number! The VIN number is 17 characters long The VIN number is 17 characters long

Production year is mandatory. Production year must not be less than 1960. Production year cannot be greater than 2024. Production year format is incorrect.

All you need to know about the door telescope

The door telescope of the luggage space is a device, which facilitate opening and closing the cover of luggage space, the weight of the luggage space cover is supported by gas spring, thus preventing eventual dropping. The gas spring has a special gasket and synthetic oil, which ensure that the device operates properly among any conditions.

Types of gas spring

- - Based on design
    - - With one rod having “rod-down” design
      - With double rod, with changeable orientation of the rod
      - Gas spring with oil chamber
  - According to attenuation effect
    - - Hydraulic
      - Dynamic

Tips for handling the door telescope

- - The door telescopes are designed for long life span, so they can be used practically for an unlimited period of time. The ageing is influenced by the habit of using. Environmental and external mechanical effects hinder its operation. The regular cleaning of the piston rod is important to extend the life span

Signs of faulty door telescope

- - Physical effort is necessary to open the luggage compartment or engine hood.
  - The door cannot stay in open condition

Reasons of faulty door telescope

- - Influence by external force
  - Inadequate lubrication at the seals

Reasons of faulty door telescope

The gas spring cannot be repaired. The part has to be replaced in case of fault. The replacement shall be made as follows:

- - Fix the open hood with some support.
  - Loosen the fasteners and remove the part
  - Install the new gas spring
  - Remove the support and check the proper operation

FAQ

Can't find what you're looking for?
Look around in the help center.

Is it possible to repair the gas spring?

This part cannot be repaired. The eventual problems can be resolved by replacing. Dismantling of the part is dangerous, because it is filled with high pressure gas.
The following faults indicate that replacement is necessary:
- - Oil stains on the cover
  - Corrosion traces
  - Fails to operate
It is desirable to replace them in pairs, because their life span is identical. It is recommended to apply lubricant regularly on the fastening elements for extending the life span.

Is it complicated to replace the door telescope?

The steps of replacement might vary depending on the model and make, but the replacement is to be made with the following steps generally:

Fix the luggage compartment cover in open condition with some supports.
Remove the cover of luggage compartment as necessary for getting access to the fastening elements.
Remove the gas spring.
It is required to vent the new part:
Push the rod into the cylinder until it stops
Wait a few seconds and release it, so that it would return to its original position.
Repeat this procedure 10 times
Install the new part
Check the proper operation of the new part